Вы не вошли. Пожалуйста, войдите или зарегистрируйтесь.
Hello,
any one guide us how to configure Technoton DUT E232 type fuel sensor with LMU-900 Device.
What Should i change in protocol to get the data on interface.
on which port sensor data would be show? Or how to create sensor? using which parameter?
first must configure DUTE to send serially to the LMU and load an accumulator using standard AT commands on wialon side is so easier to add a sensor based on this acc value, please refer to the DUTE Manual
small_gprs,
can u guide me in detail.
my email is
shabbir.sarrahraj@gmail.com
i'll show you here
in the parameter configurator start in ASCII Mode
the command to load the accumulator of GPS is
AT$APP ACC SET AA XXXX
WHERE THE AA is the accumulator number and XXXX IS THE VALUE FROM THE CAPACITIVE FUEL SENSOR OF TECHNOTON
So the complete command must be of 3 parts
Header
Value
Footer
the HEADER is AT$APP ACC SET 0 the VALUE is AUTOMATICALLY INSERTED BY THE DUTE-232 and finally the footer is a CR + LF (carriage return and line feed)
Please feel free to ask me any thing you need about FUEL SENSORS from most vendors
cheers!
