1

Charting of Sensors

Тема: Charting of Sensors

Is it possible to have the sensors being able to be shown on the chart with the parameters in the messages tab. At the moment you can have the messages show the sensor data but when you click on the chart you get the parameters and not the sensors.

We want to be able to compare the raw data values to the calculated sensor values.

Phoenix Solusi
Mobile Visible Secure
Specialists in data acquisition and analysis for mobile and fixed assets. Integration in to content management systems is a specialty we have.
2

Charting of Sensors

Re: Charting of Sensors

Is there any thinking of having this capability available?

Phoenix Solusi
Mobile Visible Secure
Specialists in data acquisition and analysis for mobile and fixed assets. Integration in to content management systems is a specialty we have.
3

Charting of Sensors

Re: Charting of Sensors

JohnG, that capability is possible theoretically.
but i don't see much support of your idea of other users.

se we will keep that in mind, but cannot promise you any specific release date

4

Charting of Sensors

(31/03/2014 06:15:04 отредактировано JohnG)

Re: Charting of Sensors

Hi Aliaksandr I spose it depends on where in the world people are and how their customers work with Wialon. Our customers want to create a sensor say a temperature sensor that is showing millivolts coverted to temperature shown in degrees C. This we can do through calibration. Their monitoring people are not interested in the parameter but want to know what is the temperature in the truck they are monitoring. The same is true for fuel, they want to see liters not voltage as the voltage means nothing to them.

We are looking to make it easy for non technical users to work with the system. We allow the creation of sensors, we allow reporting on sensor values but we do not support charting sensor values, we revert to the parameter value. To me this does not make sense, and is something potential customers always question. If I start with a sensor Temperature monitor but when i want to chart the values the chart changes to param72 and shows millivolts, both of which the user does not know about as he is a monitoring person.

Plus we are looking to use the system for non mobile asset conition monitoring were we will be capturing using IPS and want to display not in the raw data value but the units it represents.

I hope this will request will get support.

Regards
John

Phoenix Solusi
Mobile Visible Secure
Specialists in data acquisition and analysis for mobile and fixed assets. Integration in to content management systems is a specialty we have.