Topic: Main Power cut-off Notification
Please give settings for main power cut-off notification for FM1120
2
19/01/2017 19:35:30Main Power cut-off Notification
- Diana
- Gurtam
- Offline
Re: Main Power cut-off Notification
You can control parameter pwr_ext or pwr_int through notification type Parameter in a message, just to set up required value range to control
Diana Cheley
Wialon Hosting Expert
Gurtam
Wialon Hosting Expert
Gurtam
3
21/01/2017 14:41:17Main Power cut-off Notification
Re: Main Power cut-off Notification
And how do we know that internal battery is ON ? and voltage of internal battery (FM1120) ?
4
21/01/2017 15:05:49Main Power cut-off Notification
Re: Main Power cut-off Notification
pwr_ext Power supply voltage (I/O property 66) V
pwr_int Battery voltage (I/O property 67)
To control internal battery voltage you can create sensor based on pwr_int.
To control external voltage, you can connect device any analog input to "+" of external battery, and then create sensor based on this analog input.
5
24/01/2017 23:35:12Main Power cut-off Notification
- wwbusch aka Buwo
- Gurtam Partner
- Offline
Re: Main Power cut-off Notification
the main importand thing is to set the trigger correct in the device config.
You need to get a new message asap when device lose external power.
by the way, battery in fm1120 lasts round about 25 minutes. than its empty.
Wolf.
Politeness dictates it to write his name on a post
6
25/01/2017 09:07:45Main Power cut-off Notification
Re: Main Power cut-off Notification
Hardware resaler told battery back up is 4 Hours
is it wrong ?
7
25/01/2017 15:39:45Main Power cut-off Notification
- wwbusch aka Buwo
- Gurtam Partner
- Offline
Re: Main Power cut-off Notification
If you dont send any message it could be ok. but if device sends every minute one message = 20 minutes
Wolf.
Politeness dictates it to write his name on a post
8
31/01/2017 20:42:37Main Power cut-off Notification
Re: Main Power cut-off Notification
pwr_int. always shows '0' please see image
albu wrote:
pwr_ext Power supply voltage (I/O property 66) V
pwr_int Battery voltage (I/O property 67)To control internal battery voltage you can create sensor based on pwr_int.
To control external voltage, you can connect device any analog input to "+" of external battery, and then create sensor based on this analog input.
9
02/02/2017 17:48:14Main Power cut-off Notification
- wwbusch aka Buwo
- Gurtam Partner
- Offline
Re: Main Power cut-off Notification
just set device to send internal voltage ;-)
Wolf
Politeness dictates it to write his name on a post