Topic: Object stopped but SW shows Moving state (green arrow)
I am having lot of problems with devices that has configured to show the movement by motion instead the Ignition connected to a wire.
The problem is always the same, the last coordinate can appear like the speed>0 so the SW shows the green arrow in the object and in the control panel.
As I experienced with other platforms, this is an old error that was filtered time ago but not wialon still.
Working in HW side is not possible as I should set to send 1 coord. x sec.;
As it was solved in other platforms was setting the device to change status from moving to stopped after X time (5-7 min.) when it is not moving and after it moves and sends the collected coordinates make a recalculation.
By now I tell clients that the place where is stopped did not have GPRs coverage but of course they do not care.
Help to solve it please.